heating chamber
英 [ˈhiːtɪŋ ˈtʃeɪmbə(r)]
美 [ˈhiːtɪŋ ˈtʃeɪmbər]
网络 加热室; 加热腔
双语例句
- This paper mainly introduce the structure design about the heating chamber of the polycrystalline silicon ingot production furnace.
着重介绍了多晶硅铸锭炉加热室的结构设计。 - Elements should have their heating sections in the furnace chamber so that no portion of the heating section extends into the furnace wall or refractory plug.
安装时应确保其发热部在炉腔内，没有超出炉壁或者难熔插栓的部分。 - Study on Temperature Control System of Priming Heating Chamber of Automobile Carriage
汽车车厢底漆烘干室控制系统设计与研究 - A heat absorption and dissipation sheet is arranged on the outer wall of a chimney and shielded by using the sheet iron and other material; thus, an upper part heating chamber is formed.
在烟筒的外壁装置吸散热片，再用铁皮或其它材料屏蔽起来，构成上部加热腔。 - The operating temperature is measured at the surface of the heating chamber, between insulation and heating chamber.
操作温度由加热间的表面（温度）来测定，在隔热间与加热间之间。 - The original construction was a complete steel structure coved by steel plates and heating chamber was placed in the top of the oven.
另外，加热系统均分为几个加热单元，加热腔嵌在炉体内。而原结构为一个加热单元放置在炉顶中部，统一加热。 - Heating chamber is pivotal part of the polycrystalline silicon ingot production furnace.
加热室是多晶硅铸锭炉的关键部件之一。 - Unique design of heating chamber can hold various columns.
独特的加热腔室设计，可放置多种规格的色谱柱。 - A lower part heating chamber is formed in the hot-blast stove made from the sheet iron or other material.
用铁皮或其它材料制做的热风炉，炉内形成下部加热腔。 - Design of Deposition Chamber and Heating Elements in the Double Chamber Deposition Equipment for Amorphous Si Solar Cell
非晶硅太阳电池双室沉积装置沉积室及加热体的设计 - Research on the Mathematical Model of Furnace Temperature Control for the Heating Chamber
加热室炉温控制数学模型的研究 - The effect of direct heating on combustion efficiency of the chamber of jet engine in the simulation test on the ground
直接加热对空气喷气发动机燃烧室地面模拟试验燃烧效率的影响研究 - Firstly, the heating chamber is employed to circulating pipe from the ascending pipe to make fuller use of the space and to reduce the height of the equipment;
其主要改进包括将加热室从原来的上升管内沸腾段的下方移到了循环管的中下部较好地利用了空间，降低设备高度； - The technology of hydraulic-electricity proportional valves have been one of the field in hydraulic transmission system, the paper states, the principle. application and improvement in the proportional hydraulic control system of stepped heating furnace and reforming and coil chamber.
电液比例技术已在液压传动及控制技术领域占有一席之地，文章着重介绍了天钢高线厂步进式加热炉及集卷芯棒液压比例阀控制系统的原理、应用及改进。 - Brine purification is also called brine pretreatment which aims to separate Ca2+? Mg2+ from raw brine before they enter heating chamber, for fear that scaling in heating tubes will affect heat transfer.
卤水净化也称为卤水的预处理，目的是将原卤中的Ca2+、Mg2+在进入加热室前分离出来，以免其在加热管中结垢而影响传热。 - Study on Influence of the Furnace Temperature in the Heating Chamber on the Hot Waved Surface of Strip
加热室炉温对带钢热瓢曲影响的研究 - Based on the principle of heat transfer, the unsteady theory ( temperature up and down) analysis the heat transfer coefficient and the retaining heat parameter for an cooling and heating test chamber's isolated heat structure is established.
本文依据传热的基本原理，针对具有空气冷却和加热功能的环境试验箱围护结构隔热层的传热特性参数&传热系数和蓄热系数，用非稳态测量方法进行了比较试验。 - Studies on the Special Installation Method of the Large Diameter Heating Furnace Radiation Chamber ( grid free)-Lifting Platform Method
浅谈无棚架安装大直径加热炉辐射室的特殊方法&升降平台法 - Character and application of the cooling by water and heating spray chamber
水冷式加热雾化室的特性及其应用 - Analysis on the reasons for the faults of the first-effect heating chamber of three-effect downstream evaporator
三顺Ⅰ效蒸发器加热室故障原因剖析 - Some defects exist in the traditional installation method of the large diameter heating furnace radiation chamber, such as, component installation difficulty, low precision, high hoisting cost, low construct progress, and the distinct unsafe.
大直径加热炉辐射室传统的安装方法存在构件安装困难、准确性差、吊装费用高、施工速度慢和不安全因素明显等不足。 - Calculation and simulation of the heating process for the heating chamber is carried out by means of established mathematical models of the strip temperature feedforward control and the synthetic furnace temperature calculation.
在此基础上又通过建立带温前馈控制数模和综合炉温计算数模，进行了加热室加热过程的计算仿真。 - Analysis on the Courses and Treatments of Scaling in the Third Effect Heating Chamber
浅析Ⅲ效加热室结垢的原因及处理 - The hot working situation in the heating chamber of CAPL. including the way of heat supply. the heat equilibrium and the distribution of temperature, is introduced in this paper.
本文介绍CAPL加热变热工工况，包括加热室的供热方式、热平衡和温度分布。 - This paper introduces the equivalent and simplified heating process of the strip in the heating chamber of CAPL and establishes physical and mathematical models. On the basis of the models.
本文介绍了等效简化CAPL加热室带钢的加热过程，并据此建立了物理模型和数学模型。 - Mathematical model on the heat transfer inside the heating chamber of CAPL
CAPL机组加热室内的传热数学模型 - The ash in heating furnace reduces the productions of the device. The technology of dry ice cleaning in heating tube and convection chamber can attain the purpose of ash removal.
加热炉炉管积灰形成，导致装置降低生产量，利用干冰清洗原理及技术特点，对加热炉对流室炉管实施清洗方法和步骤，达到除灰目的。 - The application of nickel heating chamber for caustic soda production
镍管加热室在烧碱生产中的应用 - The heating chamber is circular, thus rationalizing atmosphere flow and increasing temperature uniformity in effective zone of the furnace chamber.
加热室采用圆形炉膛结构，增加了气氛流动的合理性，提高了炉膛有效加热区内的温度均匀性。